Culturejam Shoot The Moon

As with the original I've left a gap in the centre of the board for the LED and LFO to allow them to easily be bent to face each other and laid flat, ensure the LED and LDR legs don't short against any of the links or component leads in between.  Heat shrink tubing or electricians tape will be perfect to bind them together and stop external light from reaching the LDR.  If you don't do this remember you will need to box the effect or be in total darkness to test.

Info from CJ about his take on the Tremulus Lune:

For your enjoyment, here is a tremolo that is pretty much identical to the Tremulus Lune, but with 2 fewer LFO pots. I think 4 knobs for a tremolo is plenty, and if you like the idea of the Lune but think it's got too much going on, this project is one you will want to pursue.

Other changes I made from the stock Lune:

• I changed a few parts values to make them a bit more "standard"
• I added a resistor (R16) and cap (C7) to isolate the LFO from the audio path. It might be overkill, but I like to err on the side of caution to avoid LFO ticking.
• I ditched the 9v regulator. I see why it would be there, but if 9v is the specified input voltage, a 9v regulator doesn't really make a lot of sense. Usually you need to give a regulator a volt or two more than its rated output to get to work properly. So I just got rid of it.
• I switched the input and output caps from electrolytic to film caps. However, if you are making your own layout, you can still use electrolytics if you wish, of course.

And an even more simplified 2 knob version with switch to select sine or square wave and gain trimmer.

Video of Geiri's build of the 2 knob version: